How to Thread a Juki Sewing Machine: A Step-by-Step Guide

How to Thread a Juki Sewing Machine: A Step-by-Step Guide

How to Thread a Juki Sewing Machine: A Step-by-Step Guide
Threading your sewing machine correctly is vital to achieving the best stitching results and preventing issues such as thread breakage or skipped stitches. As a leading distributor of Juki sewing machines and apparel manufacturing equipment, MySewingMall.com is here to assist you with a comprehensive guide on how to thread a Juki sewing machine.
In this blog, we will take you through a step-by-step process on how to thread your Juki sewing machine to ensure smooth and hassle-free sewing.
Step 1: Gather Your Supplies
Before you start threading, make sure you have the following essentials:
A spool of thread compatible with your fabric and project
A compatible bobbin
A pair of small scissors or snips
Juki sewing machine manual for reference (if needed)
Step 2: Wind the Bobbin
Properly winding the bobbin is the first crucial step. Here's how:
Place your spool of thread on the spool pin, securing it with the spool cap.
Guide the thread through the thread guide(s) as indicated in your machine's manual.
Take the thread end and pass it through the hole of the empty bobbin from the inside to outside, leaving a tail of about 3 inches.
Place the bobbin onto the bobbin winder shaft and push it to the right.
Hold the tail of the thread, and begin winding the bobbin either by pressing the foot pedal or pressing the start button. (Depending on your machine model)
After winding a few layers, stop, trim the thread tail close to the bobbin, and continue winding until the bobbin is full.
When the bobbin is full, cut the thread, remove the bobbin, and push the bobbin winder shaft back to the left.
Step 3: Prepare the Machine for Threading
Turn off the sewing machine before threading to avoid needle accidents.
Raise the presser foot to release the tension disks and ease threading.
Rotate the handwheel until the take-up lever is at its highest position.
Step 4: Thread the Upper Part
Follow these simple steps to thread the upper part of your Juki sewing machine:
Place your spool of thread on the spool pin, securing it with the spool cap.
Guide the thread through the thread guides, typically starting from the top thread guide to the take-up lever.
Thread the take-up lever by passing the thread through its eye from right to left.
Continue passing the thread down through the remaining guides, usually located above and below the needle bar.
Thread the needle from front to back, leaving a tail of 4-6 inches.
Step 5: Thread the Bobbin Case
Hold the freshly wound bobbin so that the thread unwinds counterclockwise.
Insert the bobbin into the bobbin case, and follow the thread guide on the case.
Guide the thread through the tension spring, leaving a tail of 3-4 inches.
Depending on your machine model, insert the bobbin case into the hook race or drop-in bobbin system.
Step 6: Bring the Bobbin Thread to the Top
Hold the upper thread gently with your left hand.
Rotate the handwheel towards you, allowing the needle to go down and come back up.
Gently pull the upper thread to bring the bobbin thread to the surface.
Use a blunt object, such as a small screwdriver or the tip of your scissors, to help pull up the looped bobbin thread.
Hold both threads to the back or under the presser foot, leaving a tail of 3-4 inches.
Congratulations! Your Juki sewing machine is now threaded and ready for use. By following this step-by-step guide, you'll ensure a smooth sewing experience and stellar stitching results. For more information on Juki sewing machines, accessories, and services, visit MySewingMall.com – your one-stop shop for all your apparel manufacturing needs.